E3D Volcano HotEnd til direct drive 24V
Original E3D Volcano HotEnd til direct drive 24V
The Volcano HotEnd maintains as much compatibility with the E3D ecosystem as possible. You can choose from a range of upgrades including temperature sensors and heater cartridges, as well as different nozzle materials and sizes for whatever use case you require.
Thanks to its larger melt zone, the Volcano HotEnd enables users to print thicker and wider tracks which results in dramatically reduced print times.
In addition to reduced print time, the thick tracks printed by Volcano have greater interlayer adhesion and bond to one another with improved strength. Parts printed are extremely strong, less brittle and feel much more sturdy than standard prints.
With the print volumes increasing and interest of larger 3D printed items such as furniture and automotive parts, comes a requirement to decrease the overall print time. The Volcano heater block was designed to make printing large parts more efficient by allowing the use of larger nozzle sizes and higher volumetric flow rates.
– 3 x the volumetric flow rate of the V6 HotEnd
– E3D Ecosystem compatible
– Maximum printing temperature 285°C
– All metal heatbreak
– 1 x V6 Heatsink 1.75 direct
– 1 x Volcano aluminium HeaterBlock
– 1 x Stainless steel HeatBreak 1.75mm
– 1 x Brass volcano nozzle 0.8mm 1.75 mm
– 1 x Heater cartridge 30W 24V
– 1 x Thermistor cartridge
– 1 x Thermsitor extension cable
– 1 x Collet clip 1.75m
– 1 x Collet clip 1.75mm
– 1 x V6 fixings kit
– 1 x PTFE tube
– 1 x V6 Fan duct
– 1 x 30 x 30 x 10 mm fan 24V
– 1 x M3 grub screw
– 1 x M3 washer
– 1 x Thermal paste
– 1 x Volcano sock
– 1 x Cable tie