This heat break is a direct replacement for use in E3D v6 1.75mm hot ends.
This tube made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction Electroless Nickel composite coating, often used in injection molding because of it release properties. This high lubricity plating will prevent clogging in the critical zone of hotend, where filament liquidizes. It is also very hard and corrosion resistant. Great for high abrasion filaments like Carbon Fiber, Metal filled, Aluminates, etc.
- Thread size on heater block side : M6x1
- Therad size on heatsink side: M7x1
- Stepped inside bore to improve PLA printing.
E3D v6 1.75mm hotends
Som sidder i blandt andet
Original Prusa i3 MK2
Original Prusa i3 MK2S
Original Prusa i3 MK2.5
Original Prusa i3 MK3
Original Prusa i3 MK3S
Made in USA by Micro Swiss