Beskrivelse
E3D Revo Prusa Mini Edition
No machine redesign. Revo™ Prusa Mini is a top choice if you want to update your old Prusa Mini or
Mini+ setup to the latest generation of E3D™ HotEnd technology. It has the same nozzle position,
and filament diameter. All you need to do is undo the four screws that hold the existing HotEnd and
reattach the new bracket. Easy-to-follow upgrade instructions can be found here. What’s more, your
pre-existing Prusa print profiles remain compatible with no changes necessary
Ready for Revo. Revo Prusa Edition is designed to work with Revo Nozzles, so you can perform nozzle swaps with your fingers at room temperature without complex tools or hot tightening. Each Revo Nozzle is factory sealed, making it much simpler to use and more reliable than most HotEnd technology available today.
Ready for Revo. Revo™ Prusa Mini is designed to work with Revo™ Nozzles, meaning you can
perform nozzle swaps with your fingers at room temperature without complex tools or hot
tightening. Each Revo™ Nozzle is factory sealed, making it much simpler and more reliable than most
HotEnd technology available today.
Enhanced performance. Revo™ Prusa Mini uses a Revo HeaterCore, our latest HotEnd heating and
sensing architecture. It reaches temperature much faster than a traditional aluminium heater block,
and it’s much safer: a positive temperature coefficient (PTC) means the HeaterCore can’t melt at
extreme temperatures, reducing hazards in the event of a thermal runaway.
Enhanced performance. Revo™ Prusa Mini uses a Revo HeaterCore, our latest HotEnd heating and
sensing architecture. It reaches temperature much faster than a traditional aluminium heater block,
and it’s much safer: a positive temperature coefficient (PTC) means the HeaterCore can’t melt at
extreme temperatures, reducing hazards in the event of a thermal runaway.
A new look. An anodised black heat sink distinguishes Revo Prusa Edition from its predecessor.
Please note:
-You may need to adjust your Z offset when changing nozzles.
– This kit does not include a fan. The stock Prusa fan should be reused.
– This kit does not include any PTFE tube. If you require additional PTFE it can be purchased
here
E3D Revo Prusa Mini Edition Key features:
– Max temp: 300°C
– Filament diameter: 1.75mm
– Weight: 30g
– Nozzle type: RapidChange Revo
– M12 x 1.5 thread mounting
E3D Revo Prusa Mini Edition Kit includes:
– 1 x Revo™ Micro heatsink
– 1 x Collet
– 1 x Collet clip
– 1 x Revo™ HeaterCore 24V
– 1 x Revo™ HeaterCore spring
– 1 x Prusa Mini extension cable kit
– 1 x Prusa Mini bracket
– 3 x Cable tie
– 2 x M3 square nut
Single nozzle kit:
– 1 x 0.40 Brass Revo Nozzle
Fully loaded nozzle kit:
– 1 x 0.25, 0.40, 0.60 & 0.80 Brass Revo Nozzles
